Project Description

REAR DOOR KIT FOR CABINETS

The rear panel in the EGO versions can be replaced, without drilling or modifying anything, by a door with hinges made in AISI 304L (WNR 1.4307) stainless steel scotchbrite type fine satin finish with characteristics exactly the same as the front door. The rear door can be assembled in the factory or supplied in a kit for the end customer to assemble (in this case the price has to be asked for). For cabinets with 2 doors W=1600 mm an adapting kit is needed on the centre upright so you need to pay particular attention to the ordering code which is specific for 2-doors cabinets W=1600 mm.

For 1200 mm widths, the rear door kit is not contemplated in the standard configuration but is available on request (special version to assemble in the factory)

CODEDIMENSION
EPP6018REAR DOOR W=600 H=1800 (EXTRA CHARGE)
EPP6020REAR DOOR W=600 H=2000 (EXTRA CHARGE)
EPP8018REAR DOOR W=800 H=1800 (EXTRA CHARGE)
EPP8020REAR DOOR W=800 H=2000 (EXTRA CHARGE)
EPP1018REAR DOOR W=1000 H=1800 (EXTRA CHARGE)
EPP1020REAR DOOR W=1000 H=2000 (EXTRA CHARGE)
EPP1618REAR DOOR W=800 H=1800 N.02 PIECES + UPRIGHTS KIT (EXTRA CHARGE)
EPP1620REAR DOOR W=800 H=2000 N.02 PIECES + UPRIGHTS KIT (EXTRA CHARGE)

    Name

    Company Name

    Email (required)

    Phone

    Address

    Select the type of message request (required)
    QuoteInformation

    Message

    I accept the information for the confidentiality of data